Ecology For Everyone
Check waterpoweredcarkits.bravehost.com for details. hho plans hydrogen kit plans hho instructions hydrogen generator plans water4gas plans water fuel plans hybrid conversion plans water fuel instructions hho diagram hho pdf hho Generator plans run the car on water guide to…
Energy 101: Wind Turbines
Posted on Jan 13, 2012
How Wind Turbines Work – 3D Animation
Posted on Jan 13, 2012
Hydroelectic Power – How it Works
Posted on Jan 21, 2012
How to Make Hydrogen : Using Stainless Steel Arrays to Make Hydrogen
Posted on Jan 31, 2012
Indoor Solar Heater for sliding glass door = Amazing results
Posted on Mar 9, 2012
u can try using battery acid or sulfuric acid as an electrolyte. just a drop and your water never changes colour as electrodes dont corrode.
These videos are very good !–THANK YOU !
They sell HHO kits on the internet for your car to install in your car !—-one cell will produce HHO-TRY THIS–2 nails,2 wires,,batteries an a glass of water .
I changed to titanium coated copper.the byproduct from stainless steel is a hazardous material . I run 5″ x 7″ plates no neutral . ten plates running at ten amps only, produces enough hho to run my f350 10 cyl engine and get 125 mpg .
I am curious which should be the thickness of steel and why are neutral pieces
@Cuirras I dont know if I would trust that method instead of a flashback arrestor because overtime blowoff valves might stick and it may explode anyways. If I was you I would purchase a flashback arrestor.
@Tote21 what i meant was… Can i install security valve in the bubbler and when a flashback occurs the pressure inside the bubbler will be released from the security valve… and everything will be ok… right?
@Cuirras well the bubbler is not the same as the water fuel cell and is actually designed and only in place in the event of a backfire so that it will explode instead of the cell. But they make something called a flashback arrestor and they are small pieces of plastic that only allow air to flow one way and not the other way so if a flash back took place (backfire), it would stop at that point. But even in the event that it did not work, the bubbler would be where it stopped.
@Tote21 what happens then… if the backfire goes to the bubbler than the bubbler will explode right incase of pressure. Or you can add some security valve to the bubbler that can only release air from inside and suck air from outside. In that case of backfire when it goes to the bubbler than the pressure will just be released and everything will be ok right?
@thetrico The bubbler is used in the event of a backfire, it goes into the water instead of going back to the hydrogen generator jar itself causing an explosion. It’s to keep from having an explosion.
how about water?
what kind of water it is work as well?
no need to change water in the box?
how often to change water?
The Oil companies are trying their best to stop free energy ideas from spreading to common ppl.
We need to put an end to this corruption ,start generating your own electricity now.
Visit LT-MAGNET-MOTORdotCOM and get the blueprints . Join the Revolution!!
Hi budy, can you help me? Why you need the bubbler? I don´t know for what it´s used for…
Thanks.